The 5 part face mould has finally successfully completed printing! The front part of the mould alone took 65 hours... and I started doing some sanding on it with filler spray, sand paper and water to reduce the stepping effect... before I realized I had not yet taken a photo to document the completed mould print. Oh well, what can you do. Not printing another 65 hour front part just for the photo. Hope this sanding work is not messing up the mould either. Guess we'll soon see. Still have to stick the magnets and complete the sanding & surface treatment. Then it's casting time!
0 Comments
Leave a Reply. |
Dev logHi! This is Matt. I'm using mattslog.com as a place to record the development of projects I'm working on... as well as noting down some random thoughts and reminders... perhaps a little journaling. In short ... it's the place where I post my s... tuff. Categories
All
Archive
August 2024
fundingYou can support my work by donating to the following bitcoin address: Or by doing some of your everyday hygiene, wellness and nutritional shopping on our online shop.
|