After that little resin printing de-tour I have returned to FDM printing. Gotta say it feels good to be rid of that messy, toxic stuff. This time using an Ender 5 pro and Spidermaker PLA filament. Fingers crossed results will be better than before. Modded the printer a little by adding supports under the build plate to make it stiffer using the white filament that came with the printer. Now it's time for a real test. Making the modified front part of Aleysha's face mould again because there was a problem behind the jaw that destroyed the silicone in the de-molding process. Too much of an undercut... Will need to print the side parts again as well. Hopefully I have all the settings right to get a good result. It's a big print. 2+ days at 0.12 layer hight. Should have documented the making of the part better on the first run. What did I do and what settings did I use?
0 Comments
Leave a Reply. |
Dev logHi! This is Matt. I'm using mattslog.com as a place to record the development of projects I'm working on... as well as noting down some random thoughts and reminders... perhaps a little journaling. In short ... it's the place where I post my s... tuff. Categories
All
Archive
August 2024
fundingYou can support my work by donating to the following bitcoin address: Or by doing some of your everyday hygiene, wellness and nutritional shopping on our online shop.
|