Skull Assembly

After sanding and grounding and spray painting the skull a little it was time for a complete assembly. Everything fits well into place and the jaw articulates well. 

For the assembly I got some 2mm diameter aluminum crafting wire (2x 4cm long pieces) and M3 stainless steel screws. The ends of the aluminum crafting wire are wrapped with black duct tape as I originally planned for 3mm diameter wire. But that turned out to be too tough to bend. 

Here is a back view of the skull and the screws. The back of the skull is really rough as that's where all the print support structures were and I did not bother cleaning it up properly as this will be hidden in the joint between the skull face and the cranium part of the skull